Mouse Abcb11 ELISA Kit
Mouse Abcb11 ELISA Kit - Information
The ELISA Genie Mouse Abcb11 ELISA Kit can assay for Mouse Abcb11 in the following samples: serum, blood, plasma, cell culture supernatant and other related supernatants and tissues.How our Mouse Abcb11 ELISA Kits Work?
The ELISA Genie (enzyme-linked immunosorbent assays) assay kits are designed for the quantitative measurement of analytes in a wide variety of samples. As today's scientists demand high quality consistent data for high impact journals, ELISA Genie have developed our range of sensitive, fast and reliable ELISA kit assays to meet and exceed those demands. Our assay kits use a quantitative sandwich ELISA technique and each kit comes with highly specific antibodies pre-coated onto a 96-well microtiter plate.
At ELISA Genie we understand the need for speed! Therefore, we have developed an ultra-fast protocol meaning you achieve your results rapidly. So, once you have prepared and plated your samples, blanks and standards, you simply incubate with a highly specific biotin-conjugated primary antibody and Avidin conjugated to Horseradish Peroxidase (HRP) and incubate for the appropriate length of time. After washing the plate according to the protocol and addition of the TMB (3,3',5,5'-Tetramethylbenzidine) solution, the appearance of a blue colour should be detected due to an enzymatic reaction catalysed by HRP. Next step is the addition of the Stop Solution which terminates the HRP reaction and the blue colour turns yellow with the signal intensity measured on a plate reader at 450nm. The amount of bound Mouse Abcb11 is proportional to the signal generated by the reaction meaning the kit assay gives you a quantitative measurement of the analyte in your samples.
Mouse Abcb11 ELISA Kit - Data
Involved in the ATP-dependent secretion of bile salts into the canaliculus of hepatocytes.
|Detection method|| |
Sandwich ELISA Double Antibody
This immunoassay kit allows for the in vitro quantitative determination of Abcb11/Bsep/Spgp/ATP-binding cassette sub-family B member 11/Sister of P-glycoprotein concentrations in serum plasma and other biological fluids.
4'C for 6 months
Matrices listed below were spiked with certain level of Abcb11/Bsep/Spgp/ATP-binding cassette sub-family B member 11/Sister of P-glycoprotein and the recovery rates were calculated by comparing the measured value to the expected amount of Abcb11/Bsep/Spgp/ATP-binding cassette sub-family B member 11/Sister of P-glycoprotein in samples.
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Abcb11/Bsep/Spgp/ATP-binding cassette sub-family B member 11/Sister of P-glycoprotein and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
For Research Use Only
Mouse Abcb11 ELISA Kit Protocol
The below protocol is a sample protocol for Mouse Abcb11 ELISA Kit using a biotinylated detection antibody and streptavidin-HRP. Sandwich ELISAs allow for the detection and quantification of an analyte in a sample by using known analyte concentrations as standards and plotting absorbance of known concentrations vs known standard concentrations. This allows the researcher to calculate the amount of Mouse Abcb11 present in their sample.
Before adding to wells, equilibrate the SABC working solution and TMB substrate for at least 30 min at 37 Â°C. When diluting samples and reagents, they must be mixed completely and evenly. It is recommended to plot a standard curve for each test.
|1.||Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!|
|2.||Aliquot 0.1ml standard solutions into the standard wells.|
|3.||Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.|
|4.||Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.|
|5.||Seal the plate with a cover and incubate at 37 Â°C for 90 min.|
|6.||Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.|
|7.||Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.|
|8.||Seal the plate with a cover and incubate at 37Â°C for 60 min.|
|9.||Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.|
|10.||Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37Â°C for 30 min.|
|11.||Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.|
|12.||Add 90 Âµl of TMB substrate into each well, cover the plate and incubate at 37Â°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.|
|13.||Add 50 Âµl of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.|
|14.||Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.|
Mouse Abcb11 ELISA Kit components
|ELISA Microplate(Dismountable)||8×12 strips||4°C for 6 months|
|Sample/Standard Dilution Buffer||20ml||4°C|
|Biotin-labeled Antibody(Concentrated)||120ul||4°C (Protect from light)|
|Antibody Dilution Buffer||10ml||4°C|
|HRP-Streptavidin Conjugate(SABC)||120ul||4°C (Protect from light)|
|SABC Dilution Buffer||10ml||4°C|
|TMB Substrate||10ml||4°C (Protect from light)|
Other materials and equipment required:The ELISA Genie Mouse Abcb11 ELISA Kit will require other equipment and materials to carry out the assay. Please see list below for further details.
- Microplate reader with 450 nm wavelength filter
- Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
- Deionized or distilled water
- Absorbent paper
- Buffer resevoir
When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.
If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid
Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant
Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.
Mouse Abcb11 ELISA Kit Protein Information
|UniProt Protein Function:||ABCB11: Involved in the ATP-dependent secretion of bile salts into the canaliculus of hepatocytes. Defects in ABCB11 are the cause of progressive familial intrahepatic cholestasis type 2 (PFIC2). PFIC2 is an inherited liver disease of childhood which is characterized by cholestasis and normal serum gamma-glutamyltransferase activity. Defects in ABCB11 are also found in cases of chronic intrahepatic cholestasis without obvious familial history of chronic liver disease. Defects in ABCB11 are the cause of benign recurrent intrahepatic cholestasis type 2 (BRIC2). BRIC is characterized by intermittent episodes of cholestasis without progression to liver failure. There is initial elevation of serum bile acids, followed by cholestatic jaundice which generally spontaneously resolves after periods of weeks to months. The cholestatic attacks vary in severity and duration and patients are asymptomatic between episodes, both clinically and biochemically. Belongs to the ABC transporter superfamily. ABCB family. Multidrug resistance exporter (TC 3.A.1.201) subfamily.|
|UniProt Protein Details:|
Protein type:Transporter, ABC family; Transporter; Membrane protein, multi-pass; Membrane protein, integral; Hydrolase
Cellular Component: apical part of cell; apical plasma membrane; Golgi apparatus; Golgi membrane; integral to membrane; intercellular canaliculus; membrane; plasma membrane
Molecular Function:ATP binding; ATPase activity; ATPase activity, coupled to transmembrane movement of substances; canalicular bile acid transmembrane transporter activity; drug transporter activity; nucleotide binding
Biological Process: bile acid and bile salt transport; canalicular bile acid transport; drug export; multidrug transport; response to drug; transmembrane transport; transport
|NCBI Summary:||The membrane-associated protein encoded by this gene is a member of the superfamily of ATP-binding cassette (ABC) transporters. ABC proteins transport various molecules across extra- and intra-cellular membranes. ABC genes are divided into seven distinct subfamilies (ABC1, MDR/TAP, MRP, ALD, OABP, GCN20, White). This protein is a member of the MDR/TAP subfamily. Members of the MDR/TAP subfamily are involved in multidrug resistance. The protein encoded by this gene is the major canalicular bile salt transporter in humans and mice. Mutations in the human gene cause a form of progressive familial intrahepatic cholestases which are a group of inherited disorders with severe cholestatic liver disease from early infancy. [provided by RefSeq, Jul 2008]|
|NCBI GenInfo Identifier:||120432047|
|NCBI Gene ID:||27413|
|UniProt Related Accession:||Q9QY30|
|NCBI Full Name:||bile salt export pump|
|NCBI Synonym Full Names:||ATP-binding cassette, sub-family B (MDR/TAP), member 11|
|NCBI Official Symbol:||Abcb11|
|NCBI Official Synonym Symbols:||Bsep; PGY4; SPGP; ABC16; Lith1; PFIC2|
|NCBI Protein Information:||bile salt export pump|
|UniProt Protein Name:||Bile salt export pump|
|UniProt Synonym Protein Names:||ATP-binding cassette sub-family B member 11; Sister of P-glycoprotein|
|UniProt Gene Name:||Abcb11|
|UniProt Entry Name:||ABCBB_MOUSE|